Carved Wooden Football Stadium Signs on the CNC

August 30, 2018

With college football starting up I wanted to make a few stadium signs. This is the entire process I'm using to cut them out on the CNC!

Disclosure: All opinions expressed here are our own. This post may contain affiliate links that at no additional cost to you, I may earn a small commission. Read full privacy policy here.

Full build write-up here: http://bit.ly/2NwvHP0

‍Check out the signs on Etsy here: https://www.etsy.com/shop/CullumAndCo

Oramask: https://amzn.to/2wuaejh
‍Compression bit: http://bit.ly/2C0D5AO
‍60 Degree V-Bit: http://bit.ly/2wus9Gt
‍18 Degree V-Bit: http://bit.ly/2LGWaHN